In a Bass Guitar, there is a hole to adjust the Truss Rod.
There are hidden (usually covered with mica or plastic) and also there are
visible. The location is also not the same. There are at the end of the neck to
the head and some are at the end of the neck to the bridge. This adjustment can
be done by one of the key "L" or also with a screwdriver. Depending
on the type of Truss Rod itself. We can see in the image.
To adjust the Truss Rod is advisable that loosen the strings
first. Then Truss Rod set. If the neck feels convex then Truss Rod adjustment
carried out in a clockwise direction. When the neck was concave then Truss Rod
adjustment made against clockwise. This adjustment must be done carefully. Do
it slowly, because it is usually to turn the truss rod is a bit harsh. Rotate a
little and then left to stand for about 30 minutes, then the neck can be
checked again the curvature (but previously tighten the strings should be
first). Can be seen from the neck itself, nor seen from the distance between
the strings to the freeboard. Can also be done with a special tool with a neck
string gauge distance. When the felt has not been fitted, then the adjustment
carried out again slowly. Repeat these steps until the neck to your taste.
Post a Comment